PrepKiYour AI companion for entrance exam preparation
JEE PHYSICS NOTES

Experiment: Young's modulus of a wire

JEE · Physics · Mechanical Properties of Solids · Std XI

Summary

In Searle's method two identical wires hang from the same rigid support. The reference wire carries a constant dead load. The experimental wire carries a hanger on which slotted weights are added. A spirit level rests between the two frames, with one end on a micrometer screw. The extra extension of the experimental wire is read from the shift of the micrometer to level the spirit bubble again.

A graph of load F against extension Δl is a straight line through the origin up to the elastic limit (Hooke's law). The slope is F/Δl = YA/L, so Young's modulus can be obtained from the slope without relying on one reading. Beyond the elastic limit the graph curves, and the wire…

Key formulas

Young's modulus
Y = FL/(AΔl) = 4MgL/(πd²Δl)
Slope (load on y-axis)
F/Δl = YA/L
Slope (extension on y-axis)
Δl/F = L/(YA)
Elastic energy
U = ½ F Δl
Buoyed load
F = Mg(1 − ρ_liquid/ρ_load)
Maximum relative error
ΔY/Y = ΔM/M + ΔL/L + 2Δd/d + Δl/l
Least count
pitch / number of divisions

What this note covers

  • Searle's apparatus method
  • Load-extension graph
  • Calculation of Young's modulus
  • Error analysis

Solved past-paper question (JEE 2019)

A load of mass M kg is suspended from a steel wire of length 2 m and radius 1.0 mm in Searle's apparatus experiment. The increase in length produced in the wire is 4.0 mm. Now the load is fully immersed in a liquid of relative density 2. The relative density of the material of load is 8. The new value of increase in length of the steel wire is:

  1. (A) 4.0 mm
  2. (B) 3.0 mm
  3. (C) zero
  4. (D) 5.0 mm

Solution

  1. Extension of the same wire is proportional to the pulling force: Δl ∝ F. Here the force is the apparent weight of the load.

  2. When the load is fully immersed in the liquid, it is buoyed up. Buoyancy ÷ weight = (density of liquid) ÷ (density of load).

    B/W = 2/8 = 1/4

  3. So the apparent weight is three-fourths of the real weight.

    F′ = W(1 − 1/4) = 0.75 W

  4. New extension.

    Δl′ = 0.75 × 4.0 = 3.0 mm

Answer: (B) 3.0 mm

Common mistake: Keeping the same extension (4 mm), or using the liquid's density instead of the ratio of densities.

The full note has 6 solved questions, 6 practice questions, figures and a topic test. Reading it on PrepKi is free after you log in.

PDF download is included in PrepKi plans. See plans.

More notes in Mechanical Properties of Solids