PrepKiYour AI companion for entrance exam preparation
JEE PHYSICS NOTES

Elasticity problems

JEE · Physics · Mechanical Properties of Solids · Std XI

Summary

The tension in a hanging wire is not the same at every point: each section carries the weight of everything below it. So the stress is smallest at the lower end and greatest at the support. To find the extension add the small stretches of thin slices, or use the average tension. A uniform wire of weight w behaves, for its extension, as if half its weight acted at the end.

When two wires are joined end to end (series) the same force passes through both, but their extensions add. When wires hang side by side (parallel) they stretch by the same amount, and the load is shared in proportion to AY/L. A wire acts like a spring of stiffness…

Key formulas

Extension under a load
ΔL = FL/(AY)
Wire as a spring
k = AY/L
Hanging wire, own weight
ΔL = wL/(2AY) = ρgL²/(2Y)
Series wires
ΔL = ΣF L_i/(A_i Y_i); 1/k = Σ1/k_i
Parallel wires
ΔL equal; k = Σk_i
Equal L, A in series
Y = 2Y₁Y₂/(Y₁ + Y₂)
Whirled mass on a wire
T = mω²L
Rotating rod
T(x) = ρAω²(L² − x²)/2
Thermal stress
σ = YαΔT; F = AYαΔT

What this note covers

  • Wire hanging under its own weight
  • Composite wires in series and parallel
  • Rod rotating or accelerating
  • Rigid supports and thermal stress

Solved past-paper question (JEE 2021)

A uniform heavy rod of weight 10 kg ms⁻², cross-sectional area 100 cm² and length 20 cm is hanging from a fixed support. Young modulus of the material of the rod is 2×10¹¹ Nm⁻². Neglecting the lateral contraction, find the elongation of rod due to its own weight :

  1. (A) 2×10⁻⁹ m
  2. (B) 5×10⁻¹⁰ m
  3. (C) 5×10⁻⁸ m
  4. (D) 4×10⁻⁸ m

Solution

  1. The weight is 10 kg m s⁻², that is 10 N. Use ΔL = WL/(2AY). Convert area and length to SI units.

    A = 100 cm² = 10⁻² m², L = 20 cm = 0.2 m

  2. Put in the numbers.

    ΔL = (10 × 0.2)/(2 × 10⁻² × 2 × 10¹¹)

  3. Evaluate.

    ΔL = 2/(4 × 10⁹) = 5 × 10⁻¹⁰ m

Answer: (B) 5×10⁻¹⁰ m

Common mistake: Using ΔL = WL/AY. For a rod hanging under its own weight the average tension is W/2, so a factor ½ appears.

The full note has 8 solved questions, 8 practice questions, figures and a topic test. Reading it on PrepKi is free after you log in.

PDF download is included in PrepKi plans. See plans.

More notes in Mechanical Properties of Solids