Summary
When v = V₀ sin ωt is applied across a pure resistor R, the current is i = (V₀/R) sin ωt = I₀ sin ωt. The voltage and current are in phase (φ = 0). The resistance does not depend on the frequency, so R opposes AC and DC equally.
The instantaneous power p = v i = V₀I₀ sin²ωt = ½V₀I₀ (1 − cos 2ωt) is never negative and changes at twice the supply frequency (2f). Its average over a cycle is P = ½V₀I₀ = Vrms Irms = Irms² R = Vrms²/R. The heat in time t is H = Irms² R t.
Key formulas
- Instantaneous current (resistor)
- i = (V₀/R) sin ωt (in phase)
- Average power in a resistor
- P = Vrms Irms = Irms² R = Vrms²/R
- Frequency of instantaneous power
- 2f
- Inductive reactance
- XL = ωL = 2πfL; I₀ = V₀/XL
- Current in an inductor
- i = I₀ sin(ωt − π/2) (lags by 90°)
- Capacitive reactance
- XC = 1/ωC = 1/(2πfC); I₀ = V₀/XC
- Current in a capacitor
- i = I₀ sin(ωt + π/2) (leads by 90°)
- Reactance for DC (f = 0)
- XL = 0; XC = ∞
- Average power in pure L or pure C
- 0
What this note covers
- Resistor only
- Inductor only (inductive reactance)
- Capacitor only (capacitive reactance)
Solved past-paper question (MHT-CET 2024)
A series LCR circuit is subjected to an AC signal of 200 V, 50 Hz. If the voltage across the inductor (L=10 mH) is 31.4 V, then the current in this circuit is
- (A) 68 A
- (B) 63 A
- (C) 10 A
- (D) 10 mA
Solution
Find the angular frequency from f = 50 Hz.
ω = 2π × 50 = 100π ≈ 314 rad/s
Change the inductance to henry and find the reactance.
L = 10 mH = 0.01 H; XL = ωL = 314 × 0.01 = 3.14 Ω
The same current flows through every element of a series circuit, so use the voltage across the inductor.
I = VL/XL = 31.4/3.14 = 10 A
Answer: (C) 10 A
Common mistake: Dividing the source voltage (200 V) by XL. Only the voltage across the inductor is used here, and mH must be changed to H.
The full note has 8 solved questions, 8 practice questions, figures and a topic test. Reading it on PrepKi is free after you log in.
PDF download is included in PrepKi plans. See plans.