Summary
A p-n junction diode conducts when forward biased and blocks when reverse biased. Connect it in series with an a.c. source and a load resistor R_L. Only the half-cycle that makes the p-side positive drives current through R_L, so the output is a train of positive pulses: it is pulsating d.c., not steady d.c.
Take the peak of the a.c. as V_m (V_m = √2 × V_rms of the a.c. supply). For the ideal half-wave output: V_dc = V_m/π ≈ 0.318 V_m, V_rms = V_m/2, efficiency η = 40.6 %, ripple factor r = 1.21 and PIV = V_m. The output frequency equals the input frequency f.
Key formulas
- Peak from rms
- V_m = √2 V_rms
- Half-wave d.c. value
- V_dc = V_m/π ≈ 0.318 V_m
- Full-wave d.c. value
- V_dc = 2V_m/π ≈ 0.637 V_m
- Half-wave rms value
- V_rms = V_m/2
- Full-wave rms value
- V_rms = V_m/√2
- Efficiency (max)
- Half-wave 40.6 %; full-wave 81.2 %
- Ripple factor
- r = I_ac(rms)/I_dc; half 1.21, full 0.48
- Ripple frequency
- Half-wave f; full-wave 2f
- Peak inverse voltage
- Half-wave V_m; centre-tap 2V_m; bridge V_m
What this note covers
- Half-wave rectifier
- Full-wave rectifier
- Ripple and filters
Solved past-paper question (MHT-CET 2024)
A semiconductor device X is connected in series with a battery and a resistor. The current of 10 mA is found to pass through the circuit. If the terminals of X are connected in reverse manner, the current drops to almost zero. X may be
- (A) a zener diode
- (B) a p-n junction diode
- (C) an intrinsic semiconductor
- (D) an extrinsic semiconductor
Solution
The device passes 10 mA one way and almost nothing when reversed, so it has one-way conduction.
I (forward) = 10 mA
I (reverse) ≈ 0
A p-n junction diode does exactly this: forward bias narrows the depletion layer and a large current flows; reverse bias widens it and only a tiny leakage current flows.
A plain intrinsic or extrinsic semiconductor is just a resistor. It carries the same current in both directions, so options C and D are out.
A zener diode is used for its large current in reverse breakdown. The question describes ordinary rectifying behaviour, so the ordinary p-n junction diode fits best.
Answer: (B) a p-n junction diode
Common mistake: Choosing the zener diode just because it is also a diode.
The full note has 6 solved questions, 6 practice questions, figures and a topic test. Reading it on PrepKi is free after you log in.
PDF download is included in PrepKi plans. See plans.