PrepKiYour AI companion for entrance exam preparation
JEE PHYSICS NOTES

Transistors

JEE · Physics · Semiconductor Electronics: Materials, Devices and Simple Circuits · Std XII

Summary

A transistor is a three-layer, two-junction device made by joining a thin base between an emitter and a collector. In an npn transistor the base is p-type and the other two regions are n-type; in a pnp transistor it is the other way round. The three regions are doped very differently, and that is what makes transistor action possible.

In the active region the emitter pushes carriers into the base. Because the base is thin and lightly doped, only a small part (a few per cent) recombines and forms the base current IB. Most carriers are swept across the reverse-biased collector junction and form the collector current IC. The emitter current is the sum of the two.

Key formulas

Currents
IE = IB + IC
Common-base gain
α = IC / IE
Common-emitter gain
β = IC / IB = ΔIC / ΔIB
α and β
β = α / (1 − α), α = β / (1 + β)
Output voltage of CE amplifier
Vout = VCC − IC RC
Voltage gain
Av = β R_out / R_in
Power gain
Ap = β² R_out / R_in
Saturation collector current
IC(sat) ≈ VCC / RC
Base loop
VBB = IB RB + VBE
Phase change in CE amplifier
180°

What this note covers

  • Structure of npn and pnp transistors
  • Transistor action and configurations
  • Transistor as an amplifier
  • Transistor as a switch

Solved past-paper question (JEE 2016)

An unknown transistor needs to be identified as npn or pnp type. A multimeter, with +ve and –ve terminals, is used to measure resistance between different terminals transistor. If terminal 2 is the base of the transistor then which of the following is correct for a pnp transistor ?

  1. (A) +ve terminal 3, –ve terminal 2, resistance high
  2. (B) +ve terminal 2, –ve terminal 3, resistance low
  3. (C) +ve terminal 1, –ve terminal 2, resistance high
  4. (D) +ve terminal 2, –ve terminal 1, resistance high

Solution

  1. In a pnp transistor the base is n-type and the emitter and collector are p-type. Take the +ve terminal as the one that applies the positive potential.

  2. A p–n junction conducts (low resistance) when the p-side is positive and the n-side is negative, and blocks (high resistance) the other way round.

    p positive, n negative: low resistance

    n positive, p negative: high resistance

  3. Option D puts +ve on terminal 2 (the base, n-side) and −ve on terminal 1 (p-side). This is reverse bias, so the resistance is high. This matches the option.

    +ve base (n), −ve p: reverse, high resistance

  4. Check the rest. A and C put +ve on a p-side and −ve on the base: that is forward bias, so the resistance would be low, but both options say high. B puts +ve on the base and −ve on a p-side: reverse bias, but it says low.

Answer: (D) +ve terminal 2, –ve terminal 1, resistance high

Common mistake: Mixing up which side must be positive for forward bias. In a pnp transistor the base is n-type, so positive on the base is reverse bias.

The full note has 5 solved questions, 5 practice questions, figures and a topic test. Reading it on PrepKi is free after you log in.

PDF download is included in PrepKi plans. See plans.

More notes in Semiconductor Electronics: Materials, Devices and Simple Circuits