Summary
Conduction is the transfer of heat through a material from the hot part to the cold part, without any bulk movement of the material. Particles at the hot end vibrate more and pass energy on to their neighbours. In metals, free electrons carry the energy as well, so metals are good conductors. Conduction is the main mode of transfer in solids.
In the steady state the temperature at each point stays constant, so the rod absorbs no heat and the same heat current H flows through every section. The temperature then falls uniformly along the rod.
Key formulas
- Heat current (conduction)
- H = Q/t = kA(T₁ − T₂)/L
- Thermal resistance
- R = L/(kA) (unit K W⁻¹)
- Unit of k
- W m⁻¹ K⁻¹
- Series (same A)
- R = R₁ + R₂; H same in each rod
- Series, equal L, equal A
- k = 2k₁k₂/(k₁ + k₂)
- Parallel
- H = H₁ + H₂; kA = k₁A₁ + k₂A₂
- Speed of thermal radiation in vacuum
- c = 3 × 10⁸ m s⁻¹
What this note covers
- Conduction and thermal conductivity
- Conductors in series and parallel
- Convection
- Radiation
Solved past-paper question (NEET 2019)
The unit of thermal conductivity is:
- (A) W m K⁻¹
- (B) W m⁻¹ K⁻¹
- (C) J m K⁻¹
- (D) J m⁻¹ K⁻¹
Solution
Start from the conduction law and make k the subject.
H = kA ΔT / L
k = H L / (A ΔT)
Put in the SI units: H in watt (W), L in metre (m), A in m², ΔT in kelvin (K).
k = W × m / (m² × K)
Cancel one power of the metre.
k = W m⁻¹ K⁻¹
Options A and C have the metre in the numerator, and C and D use joule without time. Only option B matches. Option B.
Answer: (B) W m⁻¹ K⁻¹
Common mistake: Writing W m K⁻¹ or J m K⁻¹: the length goes in the denominator, because k = HL/(AΔT).
The full note has 7 solved questions, 7 practice questions, figures and a topic test. Reading it on PrepKi is free after you log in.
PDF download is included in PrepKi plans. See plans.