Summary
A current-carrying coil of N turns and area A in a magnetic field B feels a torque τ = NIAB sinθ. In the galvanometer the coil hangs between concave pole pieces round a fixed soft-iron cylinder. The field in the gap is then radial, so the plane of the coil is always parallel to B and the torque is always NIAB, whatever the deflection.
An ammeter must measure large currents and must not disturb the circuit, so its resistance must be very small. A low resistance S (the shunt) is joined in parallel with the galvanometer. Only the small current Ig passes through the coil; the rest, I − Ig, goes through the shunt. The two are in parallel, so…
Key formulas
- Shunt for range I
- S = Ig G / (I – Ig)
- Same, with n = I / Ig
- S = G / (n – 1)
- Resistance of the ammeter
- RA = G S / (G + S), which is less than S
- Resistance to add for range V
- R = V / Ig – G
- Resistance of the voltmeter
- RV = G + R = V / Ig
- Extending a voltmeter of range V₁ and resistance R₁ to V₂
- extra resistance = R₁ (V₂ – V₁) / V₁
- Deflection of the coil
- φ = NIAB / k
- Current sensitivity
- CS = φ / I = NAB / k
- Voltage sensitivity
- VS = φ / V = CS / R
- Figure of merit
- I / φ = 1 / CS
What this note covers
- Moving coil galvanometer
- Galvanometer into ammeter (shunt)
- Galvanometer into voltmeter (series resistance)
- Current and voltage sensitivity
Solved past-paper question (JEE 2024)
A moving coil galvanometer has 100 turns, and each turn has an area of 2.0 cm². The magnetic field produced by the magnet is 0.01 T, and the deflection in the coil is 0.05 rad when a current of 10 mA is passed through it. The torsional constant of the suspension wire is x×10⁻⁵ N-m/rad. The value of x is:
Solution
In equilibrium the magnetic torque on the coil balances the restoring torque of the suspension.
NIAB = kφ
Convert to SI units.
A = 2.0 cm² = 2.0 × 10⁻⁴ m²
I = 10 mA = 10⁻² A
Make k the subject and substitute.
k = NIAB / φ = (100 × 10⁻² × 2 × 10⁻⁴ × 0.01) / 0.05
Simplify the numerator and divide.
k = 2 × 10⁻⁶ / 0.05 = 4 × 10⁻⁵ N m/rad
Comparing with x × 10⁻⁵, the value of x is 4 (numerical-answer question).
Answer: 4
Common mistake: Writing the area as 2 × 10⁻² m² (forgetting that 1 cm² = 10⁻⁴ m²).
The full note has 6 solved questions, 6 practice questions, figures and a topic test. Reading it on PrepKi is free after you log in.
PDF download is included in PrepKi plans. See plans.