Summary
A rectifier turns AC into one-way (pulsating DC) using the one-way conduction of a p-n junction diode. A half-wave rectifier uses one diode: it conducts only in the half-cycle in which it is forward biased, so only half of each cycle reaches the load. The output frequency equals the input frequency. A capacitor across the load charges to nearly the peak voltage while the diode conducts and discharges slowly through the load in between, which smooths the ripple.
A full-wave rectifier uses two diodes with a centre-tapped transformer. D₁ conducts in one half-cycle and D₂ in the other, so both halves reach the load in the same direction. The output pulses twice per cycle, so the ripple frequency is 2f.…
Key formulas
- Peak from r.m.s.
- V₀ = √2 V_rms
- Half-wave mean (DC) output
- V_dc = V₀/π ≈ 0.318 V₀
- Full-wave mean (DC) output
- V_dc = 2V₀/π ≈ 0.636 V₀
- Output frequency
- half-wave: f; full-wave: 2f
- Zener regulator
- I = (V_in − V_Z)/R_s; I_Z = I − V_Z/R_L
- Maximum Zener current
- I_max = P_max / V_Z
- Photon energy
- E = hc/λ = 1240 eV nm / λ
What this note covers
- Half-wave rectifier
- Full-wave rectifier
- Zener diode and voltage regulator
- Photodiode, solar cell and LED
Solved past-paper question (NEET 2022)
In half wave rectification, if the input frequency is 60 Hz, then the output frequency would be:
- (A) 60 Hz
- (B) 120 Hz
- (C) zero
- (D) 30 Hz
Solution
In a half-wave rectifier the diode conducts once per input cycle, in the positive half only.
So there is exactly one output pulse for every input cycle, and the pulses repeat at the input frequency.
f_out = f_in = 60 Hz
The output frequency is 60 Hz, which is option A.
Answer: (A) 60 Hz
Common mistake: Doubling the frequency (the rule for a full-wave rectifier) or halving it because only half the wave is used.
The full note has 9 solved questions, 9 practice questions, figures and a topic test. Reading it on PrepKi is free after you log in.
PDF download is included in PrepKi plans. See plans.