Summary
Friction is the force that opposes the relative motion (or the tendency of motion) between two surfaces in contact. It acts along the surface. Static friction acts when there is no sliding: it adjusts itself to the applied force, up to a maximum (limiting) value. Kinetic (sliding) friction acts once the body slides, and it is nearly constant and smaller than the limiting static friction.
The angle of friction λ is the angle between the normal reaction N and the resultant R of N and the limiting friction f. It satisfies tan λ = f/N = μ. The angle of repose α is the angle of the incline at which a block just begins to slide down. At that angle…
Key formulas
- Limiting / kinetic / rolling friction
- f_s = μ_s N; f_k = μ_k N; f_r = μ_r N
- Angle of friction
- tan λ = μ
- Angle of repose
- tan α = μ (α = λ)
- Sliding to rest on level ground
- a = μg; t = u/μg; s = u²/2μg
- Smooth incline
- a = g sin θ
- Rough incline, down / up
- a = g(sin θ ∓ μ cos θ)
- Sand heap
- h = μr
What this note covers
- Static and kinetic friction
- Laws and coefficients of friction
- Angle of friction and angle of repose
- Rolling friction
- Motion on an inclined plane
Solved past-paper question (MHT-CET 2020)
A block of mass 'M' is pushed momentarily on horizontal surface with initial velocity 'V'. If 'μ' is the coefficient of sliding friction between the block and surface, block will come to rest after time (g = acceleration due to gravity)
- (A) μg/V
- (B) μgV
- (C) V²/(μg)
- (D) V/(μg)
Solution
While sliding, the only horizontal force is kinetic friction, which retards the block.
f = μN = μMg
Divide by the mass to get the retardation.
a = f/M = μg
The block stops (v = 0) after time t. Use v = u − at.
0 = V − μg t
Solve for t.
t = V/(μg)
Answer: (D) V/(μg)
Common mistake: Writing t = V/μ or μgV: the retardation is μg, not μ.
The full note has 8 solved questions, 8 practice questions, figures and a topic test. Reading it on PrepKi is free after you log in.
PDF download is included in PrepKi plans. See plans.